HOME
Bait&Tackle
Bed&Breakfast
Boat Rentals
Campgrounds
Contact Us
Cottage Rentals
Guides/Fishing Charters
Hotels/Motels
Hunting Supplies
Ice Huts/Ice Guides
Marinas
Outfitters
QUINTE FISHING SERIES
Resorts
Tourism
Trailer Parks
Launches
 

Quinte Fishing

Fishing Reports for the Bay of Quinte
It is currently Fri Nov 29, 2024 4:31 pm


All times are UTC - 5 hours





Post new topic Reply to topic  [ 14 posts ] 
Author Message
 Post subject: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 9:19 am 
Offline
Walleye Master
User avatar

Joined: Fri Oct 05, 2007 9:44 am
Posts: 2844
Location: Central ,NY
So, my pilot w light works fine. However when i go to turn in to a heat setting the flame just goes out. I believe its not getting propane. According to grizz he thinks its the thermocoupler. He believes its not being toldto spit some fuel out. Any ideas or repair people on here?

_________________
U.S.C.G. Licensed Captain
Pure Fishing Ambassador

Image


Top
 Profile  
 
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 9:43 am 
Offline
Walleye Wisdom

Joined: Wed Oct 24, 2012 6:28 pm
Posts: 648
If your pilot is staying on, then your thermocouple is producing enough milliamps to keep the valve somewhat open. There may be a piece of dirt or something in the orfice. Before you buy a thermocoupler, try turning it upside down and tap on the pilot and orfice a few times. Might be a piece of dirt in there. Worth a try. Or try holding a lighter to the thermocoupler while your turning it over. That way it's not losing the pilot.

_________________
LUCK HAS NOTHIN TO DO WITH IT!!!!!!


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 10:04 am 
Offline
Walleye Master
User avatar

Joined: Fri Oct 05, 2007 9:44 am
Posts: 2844
Location: Central ,NY
Thanks PK, i tried both of those methods butit didnt work. I ordered a new thermocouple for 8 dollars so im hoping

_________________
U.S.C.G. Licensed Captain
Pure Fishing Ambassador

Image


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 10:20 am 
Offline
Walleye Master

Joined: Mon Jan 24, 2011 12:05 pm
Posts: 1985
This is a little off topic, but just thought I'd share my experience with the Buddy Heater. I have a bigger hub style portable (3-4 man) and I used the Big Buddy heater. I recently switched to one of those tank top heaters which actually has less BTU, but I find it works way better. I haven't even switched the heater to high power yet. Heats up the hut fine on low. You can fill a 20 pound propane tank for the same price as 3 or 4 of those 1 pounders and probably get triple the time out of it. It's way cheaper to run, and less hassle fumbling around with those little bottles. Most people already own a BBQ tank, so basically you can get the heater for $60 instead of $150-200. I know it may be too big for a 1 man flipover, but I do know guys that use them in 2 man huts. It will also fit on a 10 pound tank if you're worried about size/weight.

Don't mean to hijack your thread Landshark, but just thought it may help some guys out in the future if they're having problems with the Buddy Heaters.

_________________
There's something wrong with that rod.
It has a bend in it!!!


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 10:39 am 
Offline
Walleye Angler
User avatar

Joined: Thu Oct 24, 2013 1:38 am
Posts: 262
Location: Kingston, East
Walleye 9 wrote:
This is a little off topic, but just thought I'd share my experience with the Buddy Heater. I have a bigger hub style portable (3-4 man) and I used the Big Buddy heater. I recently switched to one of those tank top heaters which actually has less BTU, but I find it works way better. I haven't even switched the heater to high power yet. Heats up the hut fine on low. You can fill a 20 pound propane tank for the same price as 3 or 4 of those 1 pounders and probably get triple the time out of it. It's way cheaper to run, and less hassle fumbling around with those little bottles. Most people already own a BBQ tank, so basically you can get the heater for $60 instead of $150-200. I know it may be too big for a 1 man flipover, but I do know guys that use them in 2 man huts. It will also fit on a 10 pound tank if you're worried about size/weight.

Don't mean to hijack your thread Landshark, but just thought it may help some guys out in the future if they're having problems with the Buddy Heaters.


Benifit of the buddy is the automatic shut off for CO, worth the extra few bucks IMO. Pair it with a 5lb tank and a Mr. Buddy 5' or 20' hose and avoid the 1lb tanks. I have the 5lb and hose but still pack a couple 1lbs just in case I get freeze up in the hose or tank from extended use.

_________________
I am a very quick learner and try to be the best at what I do.
My friends call it OCD. I call it Passion.


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 11:06 am 
Offline
Perch

Joined: Fri Dec 20, 2013 9:33 am
Posts: 39
https://www.youtube.com/watch?v=X2Z9aB-yEaE

Check out this video. I had the same issue and when I cleaned it with a Q Tip it fixed it. If you got your buddy heater under a year you can send it back or if you got it from Crappy Tire they will give you a new one.


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 11:11 am 
Offline
Walleye Master

Joined: Mon Jan 24, 2011 12:05 pm
Posts: 1985
I had the Big Buddy heater which has 2 burners, and takes 2 1 pounders to run it. It will gobble up that 5 pound tank in about 6-8 hours on a cold day on high, and you still need 1 pounders as backup. Keep the vents open on the hut, and open the door every once in awhile, and you don't need to worry about CO/Oxygen. As I mentioned earlier, the tank top model is probably not the best idea for a smaller hut, but anything 2 man and over, it beats the Big Buddy without a question.

_________________
There's something wrong with that rod.
It has a bend in it!!!


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 11:17 am 
Offline
Walleye Master
User avatar

Joined: Fri Oct 05, 2007 9:44 am
Posts: 2844
Location: Central ,NY
Good information fellas, thanks . I have a couple of the single burner that fit on top of the 20lb tank but they have a tendency to burn things lol

_________________
U.S.C.G. Licensed Captain
Pure Fishing Ambassador

Image


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 12:34 pm 
Offline
Walleye

Joined: Tue Feb 01, 2011 3:06 pm
Posts: 171
Location: Belleville
TheLandshark wrote:
Good information fellas, thanks . I have a couple of the single burner that fit on top of the 20lb tank but they have a tendency to burn things lol


YUP THEY DO!!! Did you know some coat zippers are plastic?


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 1:56 pm 
Offline
Guppy

Joined: Wed Feb 05, 2014 6:38 pm
Posts: 6
Location: Kitchener
Sounds like the problem is the thermocouple. I worked for a local gas utility. If your problem is still there after u replace the part pm me and I will provide other possible alternatives.


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Thu Feb 06, 2014 2:45 pm 
Offline
Walleye Master

Joined: Mon Jan 24, 2011 12:05 pm
Posts: 1985
wounded wrote:
TheLandshark wrote:
Good information fellas, thanks . I have a couple of the single burner that fit on top of the 20lb tank but they have a tendency to burn things lol


YUP THEY DO!!! Did you know some coat zippers are plastic?


It throws enough heat to warm you up, so there's no real need to lay on top of it, and you could probably take that coat off :wink:

Just kidding!!! You definitely need the room for it, and if you have it, it's the way to go.

_________________
There's something wrong with that rod.
It has a bend in it!!!


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Fri Feb 21, 2014 10:30 pm 
Offline
Walleye

Joined: Sat Sep 28, 2013 4:52 am
Posts: 165
Location: Peterborough
I am a gas technician if the thermocouple don't work try these tips check the co spill switch by removing both wires and jumping together with a small clip or jumper wire
Main burner orfice could be plugged with ice had one last week that was problem
Or could be loose connection on wires thermocouple ect
Let me know I have fixed about 6 this year for a few different ppl


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Sat Feb 22, 2014 4:18 pm 
Offline
Walleye

Joined: Sun Dec 20, 2009 7:53 am
Posts: 181
Location: belleville
I just refill the 1lb tanks with a conector a friend got me in the states. They refill to about 75% and cost about 60 cents to fill :D i walk out so need to save weight where i can


Top
 Profile  
 
banner ad
 Post subject: Re: Buddy Heater repair
PostPosted: Sat Feb 22, 2014 5:52 pm 
Offline
Walleye Master
User avatar

Joined: Fri Oct 05, 2007 9:44 am
Posts: 2844
Location: Central ,NY
Thanks men

_________________
U.S.C.G. Licensed Captain
Pure Fishing Ambassador

Image


Top
 Profile  
 
banner ad
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 14 posts ] 
banner ad

All times are UTC - 5 hours


Who is online

Users browsing this forum: Bing [Bot], willardv and 44 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB® Forum Software © phpBB Group