banner ad
 

Quinte Fishing

Fishing Reports for the Bay of Quinte
It is currently Wed Nov 27, 2024 12:47 am


All times are UTC - 5 hours





Post new topic Reply to topic  [ 7 posts ] 
Author Message
 Post subject: Down Rigger wiring
PostPosted: Fri Apr 10, 2020 3:23 pm 
Offline
Walleye Angler

Joined: Thu Jan 04, 2018 8:16 pm
Posts: 223
Hello.
I am in the process of installing Down Riggers on my boat which is prewired with Scotty down rigger outlets. One of the outlets is wired to my starting battery and the other goes up to my accessories battery. Just looking for some feedback on using the starting battery for the one rigger. I have a 9.9 Yamaha 4 stroke electric start kicker that I assume is set up to charge the battery. haven't confirmed that yet.


Thanks
Glenn


Top
 Profile  
 
 Post subject: Re: Down Rigger wiring
PostPosted: Fri Apr 10, 2020 3:54 pm 
Offline
Walleye Catcher

Joined: Sat Sep 10, 2011 6:30 pm
Posts: 451
So many ways to do this.

I would just make sure that whatever battery riggers are hooked to, is the same battery your trolling motor is charging, that way it stays topped up. I personally run my riggers off a house battery that is connected to my kicker only. Assuming that kicker is always running when riggers are being used. Riggers can draw a lot of power.

I isolate my mains from kicker/riggers with a house battery just in case. I am a bit paranoid though, many times i am 20 KMs out by myself.


Top
 Profile  
 
 Post subject: Re: Down Rigger wiring
PostPosted: Fri Apr 10, 2020 4:09 pm 
Offline
Walleye Wisdom
User avatar

Joined: Fri Apr 26, 2002 7:41 pm
Posts: 789
Location: Belleville Ontario
Sounds good. Your down riggers off the same battery being charged by your kicker motor. BATMAN


Top
 Profile  
 
 Post subject: Re: Down Rigger wiring
PostPosted: Tue Apr 14, 2020 7:46 am 
Offline
Walleye Wisdom

Joined: Mon Jan 12, 2015 6:53 pm
Posts: 842
I have a suggestion that might help on your battery wiring.

I don't have a down rigger, but I do have a trolling motor that I use all the time. I'm also bobbing around a longways out so I'm a little paranoid about my starting battery.

I have a Blue Sea Automatic Charging Relay (ARC) https://www.marineoutfitters.ca/index.c ... 2085076016 , there's a bigger one if required.
This ACR is easy to wire and protects your starting battery voltage.

How it works is the starting and house (trolling motor) batteries are connected in parallel so that the running gas motor constantly charges both batteries. The house battery runs the big voltage items. The ACR prevents the house battery from drawing on the starting battery. This means you'll only drain the house battery and still have sufficient starting voltage in your starting battery.
http://assets.bluesea.com/files/resourc ... 014350.pdf

When I'm not running my gas motor and just using my trolling motor, my trolling motor won't drain my starting battery. When I use my gas motor both batteries charge as usual.

The ACR also allows your to charge both batteries by charging either one. In my case, I have a single bank charger that is connected to my house battery and it also charges my starting battery.

I've used this setup for about 12 yrs on two different boats and have never drained a staring battery. I also carry one of those Lithium jumps starters as well.
Like I said, I'm paranoid.


Top
 Profile  
 
 Post subject: Re: Down Rigger wiring
PostPosted: Wed Apr 15, 2020 7:29 pm 
Offline
Walleye Angler

Joined: Thu Jan 04, 2018 8:16 pm
Posts: 223
Thanks guys for the help! I am still working on getting them installed. No real hurry and like to do things right. I too like to be prepared and don't want to get stranded because I could have been set up better. And I will definitely look into that ACR Robin thanks.Hope to be already for trouting in the fall/spring Virus permitting of course.

I must say, the boat sure is getting clean and shiny:). I own it with my 92 year old father and hope and pray that I get to take him out in it again. We bought it last spring so that he would be more safe and comfortable than in my old boat.
Sad to think that some people, me included, may never get to spend time with our parents again. My mother is in a long term care facility.

Glenn


Top
 Profile  
 
 Post subject: Re: Down Rigger wiring
PostPosted: Thu Apr 16, 2020 4:00 am 
Offline
Walleye Wisdom

Joined: Mon Jan 12, 2015 6:53 pm
Posts: 842
I agree with you Glenn. I volunteered in a convalescent unit where many elderly people transitioned from their homes to long term care. Lots of stories of younger days and fishing with family was a common one. Sad to think many would never get out again. I hope you can get your dad out and enjoy fishing in the sun.


Top
 Profile  
 
 Post subject: Re: Down Rigger wiring
PostPosted: Thu Apr 23, 2020 9:22 am 
Offline
Baitfish

Joined: Tue Apr 26, 2011 9:00 pm
Posts: 17
Location: Brighton
Roblin..
Very interested in your set-up with the m-ACR ... have a Lowe 165 & 50 Merc...run my downrigger off the Motor Battery.
Would you take a look at my wiring set-up..can't post an attachment here
My email is jmbonn@me.com
Thanks!
...John

_________________
...John

Lowe 165 - Merc 50 - Lowrance Hook2-5


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 7 posts ] 
banner ad

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 52 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB® Forum Software © phpBB Group