HOME
Bait&Tackle
Bed&Breakfast
Boat Rentals
Campgrounds
Contact Us
Cottage Rentals
Guides/Fishing Charters
Hotels/Motels
Hunting Supplies
Ice Huts/Ice Guides
Marinas
Outfitters
QUINTE FISHING SERIES
Resorts
Tourism
Trailer Parks
Launches
 

Quinte Fishing

Fishing Reports for the Bay of Quinte
It is currently Thu Nov 21, 2024 8:43 pm
banner ad


All times are UTC - 5 hours





Post new topic Reply to topic  [ 12 posts ] 
Author Message
PostPosted: Thu Mar 29, 2012 4:29 pm 
Offline
Guppy

Joined: Thu Oct 13, 2011 3:06 pm
Posts: 6
First of all, being new to the area, I have been monitoring this site since the fall and I am very impressed with the amount of detailed information that is shared. I feel I have learned alot about the area from where to launch to what to try on the water, thanks.

I have a GPS acting up that says "GPS Module Not Responding", I know this is not the first Lowrance to have this issue and I have done all my homework from checking wires, power to he puck and talking to Lawren at Radio World.

I'm wondering if anyone in the Quinte area has the same setup as me that I could plug my head unit into and determine if its the head unit or antenna. My antenna is the LGC-3000 with the blue connector.

Thanks in advance.

Russ


Top
 Profile  
 
PostPosted: Thu Mar 29, 2012 5:02 pm 
Offline
Site Admin
User avatar

Joined: Mon Apr 08, 2002 8:59 am
Posts: 4329
have you checked the lowrance website support section to see if there are any download updates for both the unit and the gps puck? I had the same problem with a different unit and there was a download for the gps puck that fixed the problem. Just a suggestion

_________________
Dan Elliot - A bad day on Quinte is better than a good day at work !!!
http://www.quintefishing.com


Top
 Profile  
 
PostPosted: Thu Mar 29, 2012 5:45 pm 
Offline
Guppy

Joined: Thu Oct 13, 2011 3:06 pm
Posts: 6
I'm running the 2.5 software in the unit can't find any update for the 3000 puck. Thanks anyway Dan.


Top
 Profile  
 
PostPosted: Thu Mar 29, 2012 6:06 pm 
Offline
Walleye Wisdom
User avatar

Joined: Fri Apr 26, 2002 7:41 pm
Posts: 789
Location: Belleville Ontario
Darkmistress,

Did you try all the troubleshooting tips recommended by Lowrance?

Module Not Responding LGC-3000/LGC-2000 / LGC-Baja

These GPS modules are designed to operate with NMEA 2000 compatible systems. These require a power supply to operate. This is either supplied directly to the network or through an extra cable (NMEA 2000 Power) on the unit power cable. This is often overlooked.

Ensure proper power is supplied to the unit for operation. Follow trouble shooting for blue connector unit power related issues here or red connector unit power related issues here if needed.

Ensure proper power is being provided to the GPS module. If not configured for a network, power should also be applied to the NMEA 2000 Power cable. Apply the red wire to a fused (3A) +12V supply. Ground both the black wire and the shielded ground (bare wire). To determine if an interruption in power is preventing the GPS operation, review this document.

Check and clean connections between the display portion of the unit and the GPS module. A minimum of two connections will be in the cabling and possibly more. Trace the cable and clean contacts at each connector as needed. Clean all connections with an anti-corrosion clean for electronics as needed.

Ensure that a Liner Architecture is observed if using a LowranceNET or NMEA 2000 network.

Check the terminating resistor(s). There may be one 60 Ohm terminator or two 120 Ohm terminators. Simply check the short end of the Y cable. If a hard plastic "T" is in use, check the end for the terminator. Any evidence of scorch or fowling may indicate a replacement terminator or cable should be obtained.

Isolate the RS-232 communications (NMEA-0183) cable. This will have 4 wires, yellow/Orange/Blue/Shield. Tape each wire individually and then together if not using the NMEA communications.

Update the unit and the GPS module to their latest software version. If an earlier version of software for a module is operated with an newer version of the unit, communications may not function properly. Update the unit and GPS module accordingly by following this link.

Reset the unit. Resets for your particular unit are available HERE.

After updating, check the NMEA 2000 Bus. Press menu from a main operating page and select the NMEA 2000 menu and choose the Bus Setup option. If other devices on the network are visible, check the connection at the GPS module to the network as well as other cabling between the module and other properly operating devices. If the LGC-2000 is visible, select this option to view data for software version, and additional data. The status may indicate not-configured or OK. If not configured, change the instance to 255.

Reset the network by removing power from the NMEA 2000 power cable. Keep power off for a couple minutes to allow all devices to properly reset. Reapply power to the network.

If problems persist, it is difficult to determine the actual fault due to the cables, terminators and other devices in use. Attempting operation on another available system to isolate the communication error is ideal if possible.

Note: The LCG-3000 is now obsolete. It has been replaced by the LCG-4000. Does look like there is software for the GPS module, only the LMS-520C display. I would think the 520 upgrade would have all available connecting components such as transducers and GPS units as part of the software upgrade.

BATMAN


Top
 Profile  
 
PostPosted: Fri Mar 30, 2012 8:22 pm 
Offline
Guppy

Joined: Thu Oct 13, 2011 3:06 pm
Posts: 6
all wiring checks are good, its looking like the puck is dead.

Thanks for the help Batman


Top
 Profile  
 
PostPosted: Sat Mar 31, 2012 6:14 am 
Offline
Walleye Master
User avatar

Joined: Mon Mar 26, 2007 7:48 am
Posts: 1887
Location: West Lake, ON
I have an LGC 3000 mounted on my hardtop.. Boat is in the water on a lift. Come for a drive, we'll plug your screen into my puck and see if it works. You would need your power cord though as mine won't work with your screen.

Scott
Sent from my SGH-I717M using Tapatalk

_________________
West Lake Willows Resort, Picton Harbour Inn, and Bay of Quinte Charters
Bay of Quinte Charters offers a 26' Charter Boat operating out of Picton Harbour with a fully enclosed cabin.
Picton Harbour Inn offers 31 rooms, docking, and a restaurant on the sheltered waters of Picton Harbour.
West Lake Willows offers 8 cottages and camping at the doorstep of the famous Sandbanks on West Lake.

www.bayofquintecharters.com, www.pictonharbourinn.com, www.westlakewillows.com


Top
 Profile  
 
PostPosted: Sat Mar 31, 2012 7:35 am 
Offline
Guppy

Joined: Thu Oct 13, 2011 3:06 pm
Posts: 6
I will have to see about cutting the wire harness out of my boat for the power cable( didn't really want to do that if i don't have to). I guess i was wrong in my original post the network connection on the back of the head unit is Red not Blue, its only the sonar and data connection that are blue, would this still hook up to your setup?

Thanks for the help Scott.


Top
 Profile  
 
PostPosted: Sat Mar 31, 2012 8:17 am 
Offline
Walleye Master
User avatar

Joined: Mon Mar 26, 2007 7:48 am
Posts: 1887
Location: West Lake, ON
I actually have the lgc 4000 but my understanding is that they are interchangeable. The puck connects via nmea 2000 so it will work fine. If you bring your head unit and a power cord we'll just hook you up quick and see if the puck works for you.

Scott

Sent from my SGH-I717M using Tapatalk

_________________
West Lake Willows Resort, Picton Harbour Inn, and Bay of Quinte Charters
Bay of Quinte Charters offers a 26' Charter Boat operating out of Picton Harbour with a fully enclosed cabin.
Picton Harbour Inn offers 31 rooms, docking, and a restaurant on the sheltered waters of Picton Harbour.
West Lake Willows offers 8 cottages and camping at the doorstep of the famous Sandbanks on West Lake.

www.bayofquintecharters.com, www.pictonharbourinn.com, www.westlakewillows.com


Top
 Profile  
 
PostPosted: Sat Mar 31, 2012 12:11 pm 
Offline
Guppy

Joined: Thu Oct 13, 2011 3:06 pm
Posts: 6
Scott pm sent.


Top
 Profile  
 
PostPosted: Mon Apr 02, 2012 9:39 pm 
Offline
Walleye Angler
User avatar

Joined: Mon May 19, 2003 2:38 pm
Posts: 346
Russ, I have a spare LGC 3000 antennae you are welcome to try.

Kevin


Top
 Profile  
 
PostPosted: Tue Apr 03, 2012 8:17 am 
Offline
Walleye Catcher

Joined: Tue Dec 20, 2011 1:31 pm
Posts: 436
I'm going to say its most likely your antenna. Hopefully you can take advantage of the offers from these site members and try their antenna to narrow down your problem.

If it is the antenna, the LGC-4000 is an upgraded model that updates 5 times per second so shop around before going ahead with a repair from Lowrance. It might be worth it to upgrade.

-Lawren

_________________
Radioworld 4335 Steeles Ave W, Toronto, Ontario M3N 1V7 - www.radioworld.ca

Check out our blog at www.blog.radioworld.ca


Top
 Profile  
 
PostPosted: Tue Apr 03, 2012 8:43 pm 
Offline
Guppy

Joined: Thu Oct 13, 2011 3:06 pm
Posts: 6
Scott at West Lake Willows let me slave my unit into his boat last night and we concluded it is the antenna that is dead.

Scott, thanks again for your help.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ] 
banner ad

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB® Forum Software © phpBB Group